Package include: 1 x USDX+ Transceiver 1 x Handheld Mic 1 x Charger. USDX+ USDR SDR Transceiver All Mode 8 Band HF Ham Radio QRP SSB/CW Transceiver.
Description: This is a shortwave QRP SSB/CW transceiver. Ultra-small size makes it easy to carry for outdoor use. It boasts a 1602N LCD screen and a built-in speaker. It supports connection to a PC and uses FT8, JS8, FT4 and other digital mode software control, and supports CW automatic decoding.Features: - 8 bands cover 80m/60m/40m/30m/20m/17m/15m/10m. Frequency: 80m band (3.5MHz); 60m band (5.3MHz); 40m band (7MHz); 30m band (10MHz); 20m band (14MHz); 17m band (18MHz); 15m band (21MHz); 10m band (29MHz). Excellent PCB layout design in line with high-frequency circuit design principles to ensure excellent performance. Whether using an external 13.8v power supply, it can reach 3-5W power in 8 bands, and reserve the required SOT-223 and TO-220 for upgrading. High emission efficiency, 80m/60m/40m/30m/20m efficiency is higher than 80%, 17m efficiency is higher than 70%, 15m/10m efficiency is higher than 60%.
High-precision TCXO for KDS, frequency accuracy is better than 1PPM, frequency stability is better than 0.5PPM. Ultra-small size: 83 x 38 x 124mm/3.3 x 1.5 x 4.9 (excluding protruding parts). Abundant interfaces (CAT, PTT OUT, MIC/KEY, K-head microphone). All LPF parts use 100V C0G/NP0 capacitors.Use original magnetic latching relays for Omron. Use op amp chip with lower noise than LM4562. Simple, fun and versatile QRP SSB HF transceiver with embedded DSP and SDR functions.
EER Class-E driven SSB transmit-stage. Approximately 5W PEP SSB output from 13.8V supply.
DSP filters: 4000, 2500, 1700, 500, 200, 100, 50 Hz pass-band. DSP features: Automatic Gain Control (AGC), Noise-reduction (NR), Voice-triggered Xmit (VOX), RX Attenuators (ATT), TX noise gate, TX drive control, Volume control, dBm/S-meter.
SSB opposite side-band/carrier suppression Transmit: better than -45dBc, IMD3 (two-tone) -33dBc, Receive: better than -50dBc. Multi-band support, continuously tunable through bands 160m-10m (and from 20kHz to 99MHz with loss in performance).Open source firmware, built with Arduino IDE; allows experimentation, new features can be added, contributions can be shared via Github, software-complexity: 2000 lines of code. Software-based VOX that can be used as fast Full Break-In (QSK and semi-QSK operation) or assist in RX/TX switching for operating digital modes (no CAT or PTT interface required), external PTT output/PA control with TX-delay. Simple to install modification with 8 component changes and 8 wires. Lightweight and low-cost transceiver design: because of the EER-transmitter class-E stage it is highly power-efficient (no bulky heatsinks required), and has a simple design (no complex balanced linear power amplifier required). Fully digital and software-based SSB transmit-stage: samples microphone-input and reconstruct a SSB-signal by controlling the phase of the SI5351 PLL (through tiny frequency changes over 800kbits/s I2C) and the amplitude of the PA (through PWM of the PA key-shaping circuit). Fully digital and software-based SDR receiver-stages (optionally): samples I/Q (complex) signal from Quadrature. Sampling Detector digital mixer, and performs a 90-degree phase-shift mathematically in software (Hilbert-transform) and cancels out one side-band by adding them. Three independent switchable analog front-end receiver attenuators (0dB, -13dB, -20dB, -33dB, -53dB, -60dB, -73dB). Receiver Noise floor MDS: -135 dBm at 28MHz (in 200Hz BW). Receiver Front-end selectivity: steep -45dB/decade roll-off +/-2kHz from tuned-frequency. Blocking dynamic range: 20kHz offset 123dB, 2kHz offset 78dB. VFO A/B + RIT and Split, and corresponding relay band-filter switching via I2C. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Transceivers". The seller is "taoyu_58" and is located in this country: CN.
This item can be shipped worldwide.