HF VFO for Ham SDR QRP Transceiver, 20K-220Mhz RF Generator

  
HF VFO for Ham SDR QRP Transceiver, 20K-220Mhz RF Generator. It has 10kHz to 220MHz working ranges. 0.5PPM high precise Tcxo clock, the frequency is more accurate. Tuning step of 1Hz, 10Hz, 1kHz, 5kHz, 10kHz and 1MHz. VFO for Ham SDR HAM QRP Transceiver? Used as a local oscillator on Homebrew radio receivers (such as superheterodyne, SDR, direct conversion and Homebrew QRP transceivers), a simple RF/clock generator for calibration reference or clock generation, a common 128x64 I2C OLED SSD1306 display and Si5351 module.

Intermediate frequency (IF) offset (+ or -) is adjustable. The bar graph of the signal meter through the analogs input (ADC). I2C data transmission, only need 2 lines it can be connected to the display, with high stability and accuracy of frequency generation. Equipped with generator function mode.

Initial frequency, end frequency, sweep-frequency-step can be set. 20 band presets (shortcuts) for BCB and HAM frequencies. RX/TX mode selector for Homebrew QRP transceivers. If you have any questions, please, we will reply and improve in time. Ham SDR HAM QRP Transceiver.

This is a VFO (Variable Frequency Oscillator) project that can be used for DIY self-made devices such as superheterodyne receivers, DCR transceivers, SDR transceivers or Ham QRP transceivers. It also has bar graph indicators for signal strength (S-Meter) and 20 Band presets.

And can also be used as an RF/clock generator. 1 It has 10kHz to 220MHz working ranges. 2Intermediate frequency (IF) offset (+ or -) is adjustable.

120 band presets (shortcuts) for BCB and HAM frequencies. 2RX/TX mode selector for Homebrew QRP transceivers. 1The bar graph of the signal meter through the analogs input (ADC).

It can be used as a local oscillator on Homebrew radio receivers (such as superheterodyne, SDR, direct conversion and Homebrew QRP transceivers), a simple RF/clock generator for calibration reference or clock generation, a common 128x64 I2C OLED SSD1306 display and Si5351 module. 2I2C data transmission, only need 2 lines it can be connected to the display, with high stability and accuracy of frequency generation. 3.9"L x 3.5"W x 1.6H. 1 Lithium Polymer batteries required.

Product Dimensions: 3.5 "h x 3.9 "h x 1.6 h. We reserve the right to cancel any order for any reason at any time.

We are not responsible for undeliverable addresses. All of our items, unless otherwise stated, will only run on 120 volts. Please check to make sure your country complies with these specifications.

We will work with you to resolve any problem you may have.